Module
15 min.
Create animation of your product in Autodesk Inventor
Module overview
In this module, you will set up component motion and visibility, camera rotation and generate an animation of your assembly.
This module takes approximately 15 minutes to complete. By the end of the module, you should be able to:
- Set up component motion
- Define part visibility over time
- Set up view rotation
- Render product animation
About the author
This module was developed and recorded by Thom Tremblay, Mechanical Engineer, Author, and Certified Instructor. In 1988 Thom Tremblay started working as a drafter and mechanical designer in shipbuilding, planning, casework, commercial electronics, and centrifugal compressors eventually led Thom using his skills to teach others. With over twenty years of experience consulting with businesses and educational institutions of all types and sizes, Thom has developed an understanding of how people use and learn technologies. Thom also holds professional certifications in Autodesk AutoCAD and Autodesk Inventor and is an Autodesk Certified Instructor. Thom has authored several books and online learning content on Autodesk Inventor and is authoring online learning content for Fusion.
Before you start
- Please make sure you have Autodesk Inventor software loaded.
- If you have technical difficulties, please reach out to product support.
Module downloads
These downloadable resources will be used to complete units in this module: